Sealey VS602 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE
PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL
INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
! WARNING! Ensure that Health and Safety, local authority and general workshop practice regulations are
adhered to when using tools.
! WARNING! Be very careful when working with hot, pressurised cooling systems. There is a high risk of very serious
scalding. Always wear eye protection.
! WARNING! Any work carried out on the A/C system should only be performed by an Air Conditioning
service technician following the vehicle manufacturer's service instructions or a proprietary manual to
establish the current procedure and data.
" DO NOT use lamp if damaged.
$ Maintain lamp in good and clean condition for best and safest performance.
$ Ensure that a vehicle which has been jacked up is adequately supported with axle stands.
$ Wear suitable eye protection. A full range of personal safety equipment is available from your Sealey dealer.
" DO NOT expose eyes and skin to UV light.
! ! WARNING! Never operate lamp without UV safety glasses (Sealey UV glasses SSP46).
$ Wear suitable protective clothing, gloves and eye protection when handling the dye (Leak Detection Fluid)
which can cause irritation on contact with skin and eyes. A safety data sheet covering the Leak Detection
Fluid VS60112 and VS60012 is obtainable via your local Sealey dealer.
$ Wear suitable clothing to avoid snagging. Do not wear jewellery and tie back long hair.
! WARNING! DO NOT look into the UV lamp, even if wearing UV goggles, and DO NOT point the lamp
at other people or animals.
! WARNING! Never touch UV lens filter during use - allow to cool before handling.
! ! WARNING! Maximum continuous use must not exceed 3 minutes. Allow UV lamp to cool for 10 minutes
before reuse.
$ Account for all tools and parts being used and do not leave them on or near the engine.
$ On completion of work, place the equipment back in the carry-case and store in a cool, dry, childproof area.
IMPORTANT: These instructions are provided as a guide only. Always refer to the vehicle manufacturer's
service instructions, or a proprietary manual, to establish the current procedure
and data.
2. INTRODUCTION
Ideal for detecting leaks in air conditioning and cooling systems with
the use of fluorescent dye (not included). Features robust
composite housing with rubber edge protector. Supplied with
4.33mtr cable and battery clips. Suitable for use in most lighting
conditions. For best results and protection we suggest this product
is used with UV safety spectacles (SSP46).
Part No. for Dyes:
VS60012. . . . .12 X Single dose - Aircon Dye.
VS60033. . . . .1 X 33 Dose - Aircon Dye.
VS60112. . . . .12 X Single Dose - Cooling System Dye.
INSTRUCTIONS FOR:
UV LEAK DETECTION LIGHT - 50W/12V
VS602
MODEL No.
VS602 - 1 - 030507