Mounts And Spacer Sleeves; Operating Unit - Bosch VLH 2155 Manual

5.9.4

Mounts and spacer sleeves

A mount is provided at the end of each support arm.
Abb. 5: Mount
1 Mount with rubber element
2 Height adjustment thread
3 Support arm
The mounts are positioned under the specified vehicle
jacking points and are turned to adjust the height. A
locking element stops the mounts being screwed out
too far.
i
Use the spacer sleeves provided if the height adjust-
ment of the mounts is not sufficient.
Abb. 6: Use of spacer sleeves
1 Mount with rubber element
2 Spacer sleeve
3 Support arm
!
Use is only to be made of one spacer sleeve per sup-
port arm. Spacer sleeves are never to be stacked on
top of one another.
Robert Bosch GmbH
Product description | VLH 2155 | 27
5.9.5

Operating unit

Abb. 7: Operating unit
No. Designation Function
1 Master switch Lockable ON/OFF switch with
Emergency Stop function.
2 Control lever Pressing the control lever upwards
(o) causes the lifting platform to
move upwards. Movement is stop-
ped in the following cases:
R Control lever is released.
R Upper limit value is reached.
R Switch rod is raised and trips
Pressing the control lever down-
wards (u) releases the locking
pawls and the lifting platform
moves downwards. Movement is
stopped in the following cases:
R Control lever is released.
R Lower end position is reached.
3 Locking handle The locking handle must be pulled
to be able to move the control le-
ver.
4 Working socket Connection for supplying power to
(optional) electrical equipment.
i
The lowering speed can be regulated at the control
lever: The further the control lever is pressed down,
the faster the lifting platform is lowered.
en
the limit switch.
|
1 689 989 141 2017-05-08