Se - Service Connection; Fan - Fan Connection; Cap - Capacitor Connections; Dp - Drive Power Supply Connections - Bosch rexroth NYCe 4000 Instruction Manual

Hide thumbs Also See for rexroth NYCe 4000:
Table of Contents

Advertisement

NYCe 4000 Linear motion control sys-
tem
9.3 SE – Service connection
The connector "SE" are inputs to set the operation mode of the system to
"service mode" and to execute an as fast as possible shutdown, called "stop
axes".
Connector data MC 1,5/ 4-STF-3,5
Tightening torque
Wire diameter
Tab. 9-3: SE Service connector information
9.4 Fan – Fan connection
The connector "FAN" is a power supply connector for the fan unit that can be
installed underneath the module holder for forced cooling.
9.5 CAP – Capacitor connections
One capacitor connection is available for each slot of the system housing.
WARNING
Do not touch the pins of this connector.
Do not touch the rear side of the I/O backplane.
CAUTION
Make sure that a capacitor with correct ratings is installed.
NOTICE
Observe the correct polarity of the connection of the DP drive power header.
9.6 DP – Drive power supply connections
Drive power supply for drive modules NYM04.1-2PW-NNNN-NY4120/10.
minimum
1,95 lbs*inch (0,22 Nm) 2,21 lbs*inch (0,25 Nm)
30 AWG (0,14 mm
Voltage on the pins of this connector can be
higher than 60V DC.
Maximum drive power voltage for the installed
drive module must be lower than the working
voltage of the installed capacitor.
The system housing has no provisions against
wrong polarity connection of the capacitor.
R911383227_Edition 04 Bosch Rexroth AG
Interfacing
maximum
2
)
14 AWG (1,5 mm
13/33
2
)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents