Necessary Settings On The Controller - Bosch Buderus Logamatic 5000 Series Manualline

User Documentation 7|33
for firmware smaller than 1.3.6", you have to use the old Modbus data point list and
control (see chapter "Outdated software versions and their peculiarities").
Figure 2-1: Information Menu
If, on the other hand, a firmware greater than or equal to 1.3.X is displayed, please
use the Modbus data point list with the new control that matches the firmware cur-
rently in use (see chapter "Control of the controller via Modbus TCP/IP from and in-
cluding version 1.3.X").

2.3 Necessary settings on the controller

First switch on the control and wait until it is completely ready for operation. On the
user interface, you can then open the service menu with a long click on the "Fault
message overview" icon at the bottom left.
© All rights with Robert Bosch GmbH, also for the case of protected rights applications
EN_User_documentation_Instructions_for_controlling_the_Logamatic_5000_controller_series_via_Modbus_TCP_I
P_20210203.docx | 10.02.2021