Zanussi ZWD12270W Operating Instructions

Download this manual

Operating instructions - Washer dryer Zanussi

ZWD12270W

Detergent dispenser drawer

Pre-wash

Main wash

Fabric softener

Control panel

1. PROGRAMME SELECTOR DIAL & ON/OFF SWITCH

Allows you to select a programme and/or to switch the machine on/off. It can be turned either clockwise

or anti-clockwise.

2. SPIN REDUCTION BUTTON

3. Press the spin button repeatedly to change the spin speed to a speed different from the one

suggested by the washer/dryer or to select the 'NO SPIN' or the 'RINSE HOLD' option. The relevant

light will light up

4. OPTIONS BUTTON

5. By pressing this button you can select one of the following options: Pre-wash, Intensive, Super Quick.

The relevant light will light up.

6. EXTRA RINSE BUTTON

7. By pressing this button the machine will perform additional rinses

8. DISPLAY

Page 1 Operating instructions - Washer dryer Zanussi ZWD12270W Detergent dispenser drawer Pre-wash Main wash Fabric softener Control panel 1. PROGRAMME SELECTOR DIAL & ON/OFF SWITCH Allows you to select a programme and/or to switch the machine on/off. It can be turned either clockwise or anti-clockwise.
Page 2 9. The display shows information about the programme: duration of the selected programme, selected drying time, incorrect option selection, alarm codes, heating phase, child safety lock and end of programme 10. START/PAUSE BUTTON 11. This will start the selected programme and you can also PAUSE a programme by pressing this button 12.
Page 3 Programme table...
Page 4 Operating sequence 1. Load the laundry 2. Measure out detergent – Pour required amount of detergent into main wash compartment . If you wish to carry out a prewash, pour detergent into prewash compartment 3. Measure out fabric softener – If required pour fabric softener into compartment marked without exceeding MAX level.
Page 5 Otherwise, if it is absolutely necessary to open the door, switch the machine off and wait 3 seconds. Be careful of the level and the temperature of the water in the machine! Upon restarting, the cycle will resume where it was interrupted. End of programme The machine stops automatically and the Start/Pause light goes off.