Pkd-1 Software Security Dongle; Power Amp Lga Rework Jig And St-16 Pa Stencil - Nokia 3155 Service Tools

3155/3155i (RM-41), 3152 (RM-61)
Service Tools

PKD-1 Software Security Dongle

The PKD-1 is a hardware dongle that, when connected to the parallel (LPT) port of the
PC, enables the use of the service software. It is not possible to use the service software
without the dongle. Printers or other peripheral devices can be connected to the PC
through the dongle, if needed.
Caution: Make sure that you have switched off the PC and the printer before making
connections.
Caution: Do not connect the PKD-1 to the serial port. You may damage your PKD-1
and/or your PC.
RJ-18 Power Amp LGA Rework Jig and ST-16 PA Stencil
The ST-16 stencil allows rework on LGA-type components that do not have pre-tinned
pads. Both power amps require the use of this stencil. The stencil is designed to
specifically fit the PA pad configuration and dimensions. The RJ-18 fits the physical
dimension of the PAs.
Note: Used in conjunction with the SPS-1 Paste Spreader.
Page 8
©2005 Nokia Corporation
Company Confidential ISSUE 1 07/2005