Display Assembly - HP Pavilion 14 Maintenance And Service Manual

3. Remove the fingerprint reader from the computer (3).
Reverse this procedure to install the fingerprint reader.

Display assembly

To remove and disassemble the display assembly, use these procedures and illustrations.
NOTE: The display assembly is available as a spare part only at the subcomponent level. For display
assembly spare part information, see the individual removal subsections.
Before removing the display panel, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the WLAN module (see
Remove the display assembly:
1. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
WLAN antenna cable labeled 2/AUX connects to the WLAN module Aux terminal.
2. Disconnect the display cable from the system board ZIF connector (2).
Bottom cover on page
Battery on page
WLAN module on page
The WLAN antenna cable labeled 1/MAIN connects to the WLAN module Main terminal. The
Preparation for disassembly on page
27).
29).
30).
Component replacement procedures
27).
47