Sealey PT1000G.V2 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear protective
instruction headwear
manual
1. cONTENTS
section 2. General.
section 2.1 Identification
section 2.2. Technical data
section 3. safety
section 4. operation
section 5. maintenance
section 6. Inspection/examination
section 7. Assembly
section 8. Responsibilities (of the owner/operator)
section 9. declaration of Conformity
section 10/11. Parts diagrams
2. GENERAL
2.1. Identification
supplier: sealey Power Products,
Kempson Way,
suffolk Business Park,
Bury st edmunds,
suffolk, IP32 7AR.
model no's:
PT1000G.V2, PT3000G.V2
Model capacity
PT1000G.V2 1000kg
PT3000G.V2 3000kg
Model
PT1000G.V2
PT3000G.V2
3. SAfETY
Keep trolley and beams in good working order and condition. Follow the inspection requirements as described in section 6.
9
maintenance. Take immediate action to repair or replace damaged parts by contacting your supplier. Ensure that all accessory
lifting devices are suitably certified. If damaged, remove from service immediately.
The trolley is designed to travel on a beam and carry a load up to the rated capacity. The capacity indicated on the trolley (see
9
nameplate) is the maximum safe working load which must not be exceeded.
Keep children and unauthorised persons away from the working area.
9
Keep working area clean and tidy, free from unrelated materials and ensure that there is adequate lighting.
9
© Jack sealey limited
TROLLEY GEARED 1 & 3TONNE
model no's:
Wear protective Wear protective
gloves footwear
2.2
a)
b)
c)
d)
Min/Max.
Test Load I Beam
Width
1500kg 64-140mm
4500kg 76-203mm
Minimum
Standard
Weight I-Beam
Dimensions
(D X W X Web):
17kg 125 x 75 x 5.5mm
41kg 200 x 100 x 7.0mm
Original Language Version
PT1000G.V2, PT3000G.V2
Technical Data
Rated capacity
design Capability: Test load 50% overload.
For applications see section 3 & 4.
For information on parts and materials requiring specialised
repair techniques see section 6.
Ambient operating temperature between -10°C and +50°C.
Min. curve
A
Radius
1000mm 255mm 205mm
1500mm 344mm 250mm
Maximum Standard
Maximum
Distance
Between Spans:
2500mm 250 x 125 x 7.5mm
2700mm 850 x 150 x 9.0mm
PT1000G.V2, PT3000G.V2 | Issue:2(H,F) 07/03/18
SEE TABLE BELOW
B c D
135mm 104mm
180mm 150mm
Maximum
I-Beam
Distance
Dimensions
Between Spans:
(D X W X Web):
6000mm
4500mm
E
128mm
200mm