Power Source - Sony DEV-3 Operating Manual

To use a wall outlet (wall socket) as a

power source

Make the same connections as "Step 2:
Charging the battery pack" (p. 17). Even
if the battery pack is installed, the battery
pack is not discharged.
To remove the battery pack
 Set the POWER switch to OFF (CHG).
 Open the battery cover (p. 17).
 Slide the battery release lever and
remove the battery.
Charging the battery pack abroad
You can charge the battery pack in any
countries/regions using the AC Adaptor
(supplied with DEV-3/5) or the AC Adaptor/
Charger (supplied with DEV-5K) within the
AC 100 V - 240 V, 50 Hz/60 Hz range.

Notes
Do not use an electronic voltage transformer.

Notes on the battery pack
When you remove the battery pack or

disconnect the AC Adaptor, turn this product
off and make sure that the
(Photo) lamps (p. 28), the access lamp (p. 25)
are turned off.
GB
0
Battery release lever
(Movie)/
The CHG (charge) lamp flashes during charging

under the following conditions:
The battery pack is not installed correctly.

The battery pack is damaged.

The temperature of the battery pack is low.

Remove the battery pack from this product
and put it in a warm place.
The temperature of the battery pack is high.

Remove the battery pack from this product
and put it in a cool place.
Notes on the AC Adaptor
Use the nearby wall outlet (wall socket) when

using the AC Adaptor. Disconnect the AC
Adaptor from the wall outlet (wall socket)
immediately if any malfunction occurs while
using this product.
Do not use the AC Adaptor placed in a narrow

space, such as between a wall and furniture.
Do not short-circuit the DC plug of the AC

Adaptor or battery terminal with any metallic
objects. This may cause a malfunction.