6275/6275i (RM-154) Assembly Nokia Customer Care Contents Page Safety Information ............................3 ESD Protection ............................. 3 Assembly Instructions ........................... 4 1. Insert the Camera Module ........................4 2. Insert the Camera Key and Volume/Zoom Key ................5 3. Insert the Battery Floor ......................... 6 5.
ESD protection. • ESD-protected spare part packages MUST NOT be opened/closed outside an EPA. For more detailed information about ESD protection and EPAs, contact your local Nokia Customer Care representative. Issue 1 - September 2006...
6275/6275i (RM-154) Assembly Nokia Customer Care Assembly Instructions Use the following steps to assemble the mobile terminal. 1. Insert the Camera Module Use a soldering jig or the C-cover assembly as support to replace the camera module. Ensure that the notch on the camera module aligns properly with the slot on the PWB.
6275/6275i (RM-154) Nokia Customer Care Assembly Ensure that the camera fastens in place evenly. 2. Insert the Camera Key and Volume/Zoom Key Use tweezers to insert the camera key. Use tweezers to insert the volume and zoom key. Issue 1 - September 2006...
6275/6275i (RM-154) Assembly Nokia Customer Care 3. Insert the Battery Floor Insert the battery floor, and click all of the snaps into their latches. 5. Insert the Microphone and DC Jack Insert the microphone, and lock it into the assembly.
6275/6275i (RM-154) Nokia Customer Care Assembly Use the DC plug to insert the DC jack into the assembly. 6. Insert the Flash Module Insert the flash module. Ensure that the plastic clips are click into their places correctly. 7. Insert the IHF Speaker and IHF Module Use the tweezers to insert the earpiece into the IHF module.
6275/6275i (RM-154) Assembly Nokia Customer Care Insert the IHF module into the D-cover. Ensure that all the snaps click into place. 8. Insert the LCD Module and PWB Replace the adhesive on the assembly. Align the guide tabs on the LCD module with the grooves in the assembly.
6275/6275i (RM-154) Nokia Customer Care Assembly Assemble the PWB onto the D-cover. Carefully align and press down on the flex connector until it snaps to the PWB. 9. Assemble the UI Module and Keymat Align the metal clips on the UI module, and insert it into the assembly.
Page 10
6275/6275i (RM-154) Assembly Nokia Customer Care Insert the six screws. Set the correct torque. To prevent damage to the plastic threads, turn the screws left first, then tighten them. Apply the correct torque in the order shown. Page 10 Company Confidential...
6275/6275i (RM-154) Nokia Customer Care Assembly Remove the protective film from the inside window. Insert the keymat into the A-cover. 10. Insert the A-Cover, Antenna Cover, and B-Cover Starting at the top, align the A-cover with the snaps. Carefully apply pressure and lock the A-cover to the assembly.
Page 12
6275/6275i (RM-154) Assembly Nokia Customer Care Starting at the top, align the antenna cover into the grooves of the assembly. Carefully apply pressure and snap into place. Align the B-cover with the guides on the assembly. Press down and slide the B-cover towards the top of the assembly until it clicks into place.