First Switch On; Electrical Consumption - Whirlpool PM05016 Installation And Use Instructions Manual

First switch on

Once the power supply has been connected, check that the green led on the connector side of
the control unit remains lit for more than 5 seconds.
If it remains lit: correct installation.
If it does not light up: no mains power supply and the batteries are flat or missing, check power
supply unit and battery connections.
If it flashes with a short flash and a long pause: battery operated, check power supply unit
connection.
If it flashes with a long flash and a short pause: batteries are being recharged, wait for 36
hours and replace batteries if flashing continues.
note: The batteries (5) are only to be used in the event of a power failure; always use
rechargeable AA NIMH 2000mAh minimum batteries.
technical Data
Electrical
Power supply
Control unit
Humidity range (for power supply only)
Room temperature
IP protection rating
Backup batteries (5)
►battery life

Electrical consumption

Operating mode
Tap off
Tap on
Flow rate control or mixing mode (peak)
Wall-Plug - 100-240 Vac ; 50-60 hz
9VDc= 1a
10-90%
0-40°c
IPX5 (control unit) IPX0 (Power supply)
nIMh tipo aa 1.2V - 2000mah (min.)
► 120 h with tap on stand-by
► 15 h of operation with tap on
(ma)
10
20
1200
23
EnglIsh
(W) @ 9VDc
0.09
0.18
10.8