Nokia NPM-10 Series Troubleshooting Instructions page 38

NPM-10
Troubleshooting Instructions RF
Select Calibrate.
The current values stored in Permanent Memory are shown.
Set sig. gen. settings to the freq. and amplitude specified in the popup window.
Select OK, 850 band will be calibrated and automatically stored in PM.
Phoenix will then prompt for 1900MHz calibration while displaying the current values in
PM.
Again set up sig. gen. settings as shown and select OK.
New RSSI values will be calculated and stored in PM.
RX cal is now complete.
Page 38
Nokia Corporation
CCS Technical Documentation
Confidential Issue 1 03/2003