Picklist Mode
Picklist mode enables the decoder to decode only bar codes that are aligned under the laser crosshair. Select one of the
following picklist modes for the decoder:
• Disabled Always - Picklist mode is always disabled.
• Enabled Always - Picklist mode is always enabled.
* Disabled Always
Enabled Always
Power Mode
Note: The Marathon is designed to be operated in Low Power Mode. Leave this value unchanged.
A parameter setting of Continuous On means the laser will not power down until the mobile device is powered off.
A parameter setting of Low Power means the laser will enter low power consumption mode after each decode attempt.
Pressing the Scan button will begin another decode sequence.
See
Time Delay to Low Power Mode
Select a Power Mode by scanning either of the bar codes shown below.
Continuous On
* Low Power
Presentation Mode Session Timeout
This parameter, and the Presentation Mode parameter, are directed toward decoders that can scan a bar code that enters
its field of view, determine a good read/bad read, then scan again.
13 - 16
(page 13-18).