AEG AR 4025 BT Instruction Manual page 74

ENGLISH
74
Installing the unit into the ISO dashboard slot
D
C
B
A
Detach the mounting sleeve (D) and frame (B) from
‹
the unit housing. Use the assembly keys (C) to do so.
Fit the mounting sleeve into the ISO dashboard slot.
‹
Bend the mounting sleeve tabs round with a screw-
‹
driver so that the frame is mounted securely in the
dashboard slot.
Check that the frame is secure.
‹
Connect the ISO connection of the unit to the two ISO
‹
connectors of your vehicle.
Connect the antenna cable of the vehicle antenna to
‹
the antenna adapter of the unit.
If necessary, also secure your unit against theft.
‹
Fasten the screws to the mounting bracket and to the
mounting material on the engine firewall of the car.
Slide the unit carefully into the mounting sleeve, until
‹
it clicks into place.
After all connections have been made, press the
‹
button (26) using a ballpoint pen or other pointed
object.
C
RESET
Attach the control panel (A), as described under
‹
„Attach control panel".
CAUTION:
Possible damage to the cables!
►
When inserting the unit, pay attention to the cable
routing to prevent damage.
Then mount the frame.
‹
Disassemble the unit
To disassemble the unit, proceed as follows:
Remove the frame.
‹
Insert the right and left hand assembly key into the
‹
respective slots on the sides of the unit. (The tabs are
now bent back.)
Pull out the unit.
‹
NOTE:
►
If the housing is uneven, the tabs on the mounting
sleeve may become jammed. Use the assembly keys
to release the tabs.
Installation for Toyota or Nissan
NOTE:
►
Mounting sleeve, frame and mounting strip are not
required.
Use the threaded mounting holes on the sides of the unit
(A), to fasten the unit to the mounting brackets (supplied
with your vehicle). The holes are labeled T (for Toyota) or
N (for Nissan).
D
B
C
Loosen the mounting screws for the left and right
‹
hand catches on the front of the unit and remove the
catches.
A
B