Table of Contents
Advertisement
Installation & Operation
3.1
Notes on installation
Note
Before you install the devices, read this section carefully to ensure trouble-free installation
and commissioning.
The devices can only be used in conjunction with the RTLS localization system.
The device is intended for installation in a vehicle. Installation is to be performed by qualified
and trained users according to the operating instructions. In addition, installation must take
place in accordance with the respective instructions for the installation of electrical systems
and utilities.
Note the specifications in the section "Technical specifications (Page 17)" during installation
and operation. Protect the device against moisture.
Make sure that the ambient temperature does not exceed 70 °C and that the device is not
installed in a location where it is exposed to direct sunlight.
Connection of the cables
Make sure that the wiring is correct before you start up the device.
Connection of the antenna
Connect the antenna to the RP SMA connector (ANT1). The device must not be operated
without an antenna. The device must be turned off or disconnected from the power to
change or remove the antenna.
Supply voltage
When the supply voltage is connected, all LEDs light up for 1 second.
Check whether the rated voltage of the power supply corresponds to the values in the section
"Technical specifications (Page 17)".
SIMATIC RTLS4460T
Operating Instructions, 05/2021, C79000-G8976-C522-04
3
15
Advertisement
Table of Contents
