Sealey AP4206BE Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instruction
manual
1. SAFETY
i
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using these units.
‰
WARNING! Use the rollcab on level and solid ground, preferably concrete.
‰
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Keep the units clean and tidy in accordance with good workshop practice.
9
Keep children and unauthorised persons away from the work area.
9
DO NOT use these units for any purpose other than that for which they are designed.
8
DO NOT use the units outdoors.
8
DO NOT place the units in a damp or wet location or an area where there is condensation.
8
DO NOT clean the units with any solvents which may damage the surfaces or the protective coating.
8
DO NOT move the units with the drawers out. To avoid tipping, open one drawer at a time and close and secure all drawers whilst
8
moving the rollcab.
DO NOT step on the drawers.
8
DO NOT overload the drawers, weight limit per drawer is 36kg.
8
2. INTRODUCTION
All heavy-duty steel construction and manufactured with steel inner walls for extra strength and durability. Heavy-duty 45mm ball bearing drawer
slides provide superior performance, suitable for heavier loads. Full height rear locking mechanism, locks smooth running soft close drawers
in place. Rust and solvent resistant black crinkle effect finish. Fitted with four Ø125mm PP wheels with black chrome effect alloys, two fixed
and two locking swivel castors. Each drawer features stylish black anodized heavy-duty drawer pulls plus pre-cut non-slip liners. Power tool
charging drawer fitted with 230V sockets (x2) and 5V 2.4A USB sockets (x2). Mounting points to fit additional four socket power strip - Model No.
EL34USBB (not included). Stainless steel 'flip-top' providing a work surface and additional storage. Cylinder lock for security of valuable items
locks the drawers and lid.
3. ASSEMBLY
3.1. These units are heavy, obtain the help of at least one other person before attempting to unpack them.
3.2.
Mount the side mounted handle onto the left hand end of cabinet and attach with 4 bolts (fig.1).
3.3. To remove a drawer with roller sliders, pull the drawer completely out, press down the right tab and lift up the left tab, pull drawer off
the slides To reinstall the drawer, realign with the internal drawer slide and push until it locks in place (fig.2).
3.4. Fit bottle opener to the left hand (handle) end of the cabinet using two M6 x 16 mm bolts (fig.3).
3.5. Mounting holes for an additional power rail (EL34USBB - not included) are provided at both ends of the cabinet and mounting bolts
are provided with the cabinet.
IMPORTANT: To avoid tipping, open one drawer at a time and close and secure all drawers whilst moving the rollcab/units.
© Jack Sealey Limited
1120MM MOBILE TOOL CABINET WITH
POWER TOOL CHARGING DRAWER
AP4206BE
MODEL NO:
fig.2
fig.1
Original Language Version
AP4206BE Issue 1 28/02/20