Control Panel; Data Ready; Quick Print Setup - Brother HL-1240 Quick Setup Manual

Control Panel

Drum
Ready
Paper
Alarm
Toner
Data
LED is Off
LED is Blinking
LED is On

Quick Print Setup

®
(For Windows users only)
LED
Drum
Ready
Alarm
Data
Ready +
Alarm
Alarm +
Data
Button
Cancel If you press this button while printing, the printer
immediately stops printing and ejects the paper.
printing
If the printer is in sleep mode, pressing this
Wake-up
button wakes up the printer to Ready mode.
Form feed If the Data LED is on, press this button. The
printer prints any data remaining in the printer
memory.
Error If the printer error does not clear automatically,
press this button to clear the error and continue
recovery
printer operation.
Reprinting If you press and hold this control panel button
when the Data LED is off and wait until all the
LEDs light, the printer will reprint the last job.
If there is insufficient memory, only the last page
of the job will be printed.
*1 Printer errors: "Memory full", "Print overrun",
XXX Interface error".
*2 If the Data LED is on for a long period of time and nothing
has printed, press this button to print the data remaining in
memory.
The Quick Print Setup utility allows you to make quick
changes to frequently used driver settings without
having to open the printer properties selection. When
the printer driver is selected, Quick Print Setup is
launched automatically. You can change the settings by
clicking the icon with the right mouse button. This
utility is for Windows
®
use it for Windows
Near end of life
Sleep mode
(at 1 second intervals): Warming up
Ready to print
"Cover open" or printer error.*1
No data.
Receiving data
Data remaining in memory. *2
Paper jam or No paper (in paper cassette
or manual feed slot) or paper Misfeed
( every 5 seconds ): Toner low
Toner empty
® ®
95/98/NT 4.0 only. You cannot
3.1x.