Pathworks For Macintosh Configuration - Brother NC-4100h User Manual

PATHWORKS for Macintosh Configuration

If you are using PATHWORKS for Macintosh, you will need to make sure that you
have a bi-directional channel (in other words, you did NOT enter the command SET
SERVICE servicename RECEIVE ENABLED from the remote console). Then
create a LAT port using LATCP as shown in the following example (sub-stitute your
actual node name and LAT port number):
CREATE PORT LTA53:/APPLICATION
SET PORT LTA53:/NODE=BRN_009C53/PORT=P1
Do not set the LAT port as a spooled device. Now go into ADMIN/MSA and enter
the command:
ADD PRINTER name/QUEUE=queuename/DEST=LTA53:
where name is the name of the printer, and queuename is the queue name.
CHAPTER 9 LAT NETWORK CONFIGURATION
9-9