Canon Color imageCLASS MF9170c Service Manual page 295

Chapter 16
Not used
<SYSTEM>
Sub item
DOWNLOAD Switching to the download mode
<HV-TR>
Not used
<CCD>
Sub item
DF-WLVL1 Not used
DF-WLVL2 Not used
<PARAM>
Sub item
SYS-SW
SW Bit
05 7 Switching of whether or not to prohibit exporting of PWD in the address book (0: Do not prohibit
exporting, 1: Prohibit exporting)
Sub item
SYS-NUM
FAX-SW
FAX-NUM
NET-SW
NETNUM
NET-CERT VERSION
SRLNUM
SIGALG
ISSUER
VLD_FROM
VLD_TO
SUBJECT
PUB_KEY
THMB_PRT
CDC-SW
CDC-NUM
EXC-NAVI
DSP-PPRSE
SET-PPRSZ
DSP-TNROW
SCAN-SW
SCAN-NUM
16-14
COPIER > FUNCTION > SYSTEM
COPIER > FUNCTION > CCD
COPIER > FUNCTION > PARAM
Registration of system parameters (See the table shown below.)
PARAM > SYS-SW
Function
COPIER > FUNCTION > PARAM
001 to 100
Not used
Not used
SW01 to SW50
001 to 050
CA certificate version
Serial number
Signature algorithm
Issuer
Commencement date of the expiration period
Finishing date of the expiration period
Subject of issuance
Public key algorithm and size
Digest (Thumb imprint)
Not used
Not used
Switch for whether or not to start up the installation navigation
When setting this switch to 1 after the installation navigation is completed, the installation navigation does not start up at the time
of next activation.
Setting value: 0: Start up the navigation. 1: Do not start up the navigation.
[Factory setting value/Value after RAM clearing: 0]
Setting of whether or not to display the paper setting screen when ACS setting is set to ON at the time of copy operation
Setting value: 0: Do not display the screen. 1: Display the screen.
[Factory setting value/Value after RAM clearing: 0]
Setting of the ACS document size when DSP-PPRSEL is set to ON
When the document size is unknown, a screen prompting an operator to enter the document size is displayed.
When the sizes other than UNKNOWN are specified, ACS judgment processing is performed based on the specified document
size.
Setting range: 0 to 20
Setting value: 0: UNKNOWN, 2: A4, 3: A5, 7: B5, 12: LGL, 13: LTR, 60: STMT
[Factory setting value/Value after RAM clearing: 0]
Setting of whether or not to display "Toner Low"
Setting value: 0: Do not display the screen. 1: Display the screen.
[Factory setting value/Value after RAM clearing: 1 (0 for iR C1022/iR C1022i (for US) only) ]
Not used
Not used
T-16-14
Description
T-16-15
Description
T-16-16
Description
T-16-17
T-16-18
Description
Remarks
Initial value: 1