Brother HL-1230 Quick Setup Manual page 2

1470QSG Eng_back
Black Pantone285
Follow the instructions for your interface cable and operating system.
Parallel
For interface cable users (For
Step 4 Connect the printer to your PC & Install the printer driver
Click "Connect the interface Select the parallel interface cable.
1 2
cable & install the driver / (HL-1230 users will not see this
utilities." screen.)
USB
For interface cable users (For
Step 4 Install the driver & Connect the printer to your PC
Click "Connect the interface
1
Note: When the "Add New Hardware Wizard" appears on
cable & install the driver /
your PC, click the Cancel button.
utilities."
Note: Make sure the USB interface cable is NOT
connected to the printer, and then begin installing the
driver. If you already connected the cable, remove it first.
Click the Next button. When this screen appears, make sure the printer power switch is on.
4 5
Connect the USB interface cable to your PC, and then connect it to the printer.
Click the Next button.
Step 5 Setting your printer as the Default printer
1 Click Start, Setting and Printers. 2 Select the Brother HL-
1440/1450/1470N series icon.
Network
For users (For
HL-1470N
After the administrator has made the required settings, install the driver referring to the "Installing the Driver
for Network Users" section of the Quick Network Setup Guide.
Windows
®
users only)
I O
ON OFF
Turn off the printer power switch. Connect the interface cable to your PC, and
3 4
then connect it to the printer.
Windows ®
users only)
Select the USB cable. Follow the instructions on
2 3
the screen.
I O
ON OFF
Click the Finish button.
6
For Windows ® 98/Me users: The setup is now complete.
®
For Windows 2000 users : Go to Step 5.
(For Windows ® 2000 users only)
3 Click the File menu, and then 4 The setup is now complete.
select Set as Default printer.
users only)
I O
ON OFF
Turn on the printer Follow the instructions Note: If "Add New Hardware
5 6
power switch. on the screen. Wizard" appears, click the
Cancel button.
USB
For interface cable users (For
Step 4 Install the driver & Connect the printer to your Macintosh
Click "Connect the interface cable & Note: If this screen appears,
1
install the driver / utilities." select USB cable.
I O
ON OFF
Make sure the printer power switch is on.
3
®
Connect the USB interface cable to your Macintosh , and then connect it
to the printer.
LED
Control Panel
Drum Near end of life
Ready Sleep mode
Warming up (at 1 second intervals)
Ready to print
Drum
Alarm Printer error
Data No data
Ready
Receiving data
Paper
Data remaining in memory
Alarm
Ready + Alarm Paper jam, paper misfeed or no paper
Toner
LED is OFF Alarm + Data Toner low (every 5 seconds)
Data
LED is blinking Toner empty
LED is ON
Button
Cancel printing Printer stops printing and ejects the paper.
Reprinting Printer will reprint the last job. When the Data LED is off, press and hold the button until all the
LEDs light.
Click the Next button. Click the Finish button.
7 8
The setup is now complete.
Macintosh ®
users only)
®
Follow the instructions on the screen,
2
and restart your Macintosh ® .
4 Open the Chooser from the Apple ® Click the HL-1440/50/70N icon
5
®
menu on the Macintosh . and select it.
The setup is now complete.
Press the button to wake up the printer.
Press the button to clear the error.
Press the button to print any data in memory.