Advertisement
2. SPeCIFICatIon
supply........................................................................................... 230V
speed range ......................................................................... 7200rpm
motor Power .................................................................................. 13W
noise Power .............................................................................. 65dB.A
3. oPeratIng InStrUCtIonS
3.1
Fitting/Changing engraving Head
3.1.1
ensure the tool is switched off and unplugged from the mains supply.
3.1.2
unscew the grub screw in the spindle (fig.1d).
3.1.3
remove the engraving head (fig.1c) and replace with a new one.
3.2
operation
3.2.1
check that the on/off switch (fig.1A) is set to off and then connect the tool to the mains supply. switch the tool on
3.2.2
select the stroke required on the rotary control (fig.1B). Its recommend to use a test piece to find the correct stroke suitable for the
workpiece.
note: Do not switch on with the engraving head touching the workpiece.
4. MaIntenanCe
4.1
Cleaning
4.1.1
Keep the tool ventilation slots clean and free from obstructions. If available blow compressed air into the vents to clear any internal
dust (safety goggles must be worn when undertaking this process).
4.1.2
Keep the outer case of the tool clean and free from grease.
4.1.3
Wipe down with a damp cloth.
Do not wash with water or use solvents or abrasives.
4.2
Servicing
to service the tool contact your local sealey service agent.
fig.1
tool engraver model no. e541
Bs en 28662-1:1993, Iso 8662-1:1988 results in the following vibration emission declared in accordance with Bs en 12096:1996.
Measured vibration emission value: 1.76m/s²
these values are suitable for comparison with emission levels of other tools that have been subject to the same test.
this tool may cause hand-arm vibration syndrome if its use is inadequately managed.
recommended Measures to reduce risk of hand-arm vibration syndrome:
this item represents a low Hand Arm Vibration risk to users. the calculated maximum usage period exceeds 8 hours. We recommend
appropriate safety equipment is utilised and regular breaks for the operator are employed to reduce any residual risk of fatigue or repetitive
strain injury.
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which is compatible with the environment.
When the product is no longer required, it must be disposed of in an environmentally protective way.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPortant: no liability is accepted for incorrect use of this product.
WarrantY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
InForMatIon: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
risk of Hand arm vibration Injury
when operated in accordance with these instructions and tested in accordance with
environmental Protection
Sole UK Distributor, Sealey group,
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk,
IP32 7Ar
noise Pressure .......................................................................... 76dB.A
Accessories ........................................................ engraving head (1pc)
.............................................................................letter template (1pc)
.........................................................................number template (1pc)
Uncertainty: 0.70m/s²
Original Language Version
www.sealey.co.uk
01284 757500
Web
sales@sealey.co.uk
01284 703534
email
e541 Issue: 1 - 08/07/11
Advertisement
