Bosch PLS User Manual page 8

Parking Lot Sensor | PLS
Now you can mount the sensor in the center of the parking space by applying light pressure on the sensor base (see Fig.
12 Sensor base attachment). Make sure that the sensor is centered in the parking space and that the Bosch logo on the
sensor base points towards the access road (see Figure 13 Sensor base installed). Subsequent twisting of the sensor base
is not possible.
INFORMATION:
Once the adhesive in the mixing tube has cured, it cannot be used again. At room temperature, a
typical processing time for the adhesive is about 5 minutes.
Figure 12 Sensor base attachment
Allow the two-component adhesive > 12 h to cure (hand-tight at room temperature after 30 min) before you screw in
the sensor. Keep the parking space closed off until the sensor is installed to prevent damage (such as breaking the
dome) to the sensor base.
© Bosch Connected Devices and Solutions GmbH 2021. All rights reserved, also regarding any disposal, exploitation, reproduction, editing,
distribution, as well as in the event of application for industrial property rights.
Figure 13 Sensor base installed
8 | 18