Advertisement
4.4 See fig.3. continue to assemble the next two pairs of cross
beams at the heights required. the end frames allow adjustment
in 3" increments. Each pair of beams must be mounted at the
same height. Ensure that all tabs on the cross beam brackets are
fully engaged in the slots in the uprights and that the cross
beams are properly tapped down into place.
4.5 See fig.4. Assemble the remaining two cross beams to the top
of the frame as shown below ensuring that the tabs are fully
engaged into the end frames.
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
iMpORTanT: no liability is accepted for incorrect use of this product.
WaRRanTy: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
infORMaTiOn: for a copy of our catalogue and latest promotions call us on 01284 757525 and leave your full name, address and postcode.
fig.3
fig.4
Sole Uk Distributor
Sealey group,
Bury st. Edmunds, suffolk.
4.6 See fig.5. Each wire deck 'c' is reinforced with four cross
members welded onto the underside of the mesh. Each of these
cross members has a turned down tab at either end that must
pass through slots in the cross beams. Place a wire deck onto
each pair of cross beams as shown below ensuring that it sits
into the recessed section on the top surface of each cross beam
and all tabs pass through the slots in the cross beams as shown
in the inset diagram at the bottom of fig.5.
fig.5
4.7 See fig.6. Extra components are available to create extra
storage bays as required (see section 3). In the example below a
third storage bay is achieved by joining two free standing units .
01284 757500
01284 703534
fig.6
www.sealey.co.uk
Web
sales@sealey.co.uk
email
AP6572 + AP6572E
IssuE no:2 04/11/08
Advertisement
