Optical Pick-Up Block (Cms-S76Rfs7G) (Op1) - Sony MHC-V6D Service Manual

2-28. OPTICAL PICK-UP BLOCK (CMS-S76RFS7G) (OP1)

qa optical pick-up block
(CMS-S76RFS7G)
(OP1)
5 insulator
screw
0 insulator
5 insulator screw
6 Remove the optical pick-up block
in the direction of the arrow.
4 three
claws
1 two
claws
3 Draw out the tray.
Note 3: When you can not draw out the tray,
please refer to "HOW TO OPEN THE TRAY
WHEN POWER SWITCH TURN OFF" on page 6.
Note 1: When installing the flexible flat cable, ensure that
the colored line is parallel to the connector after insertion.
OK
Insert straight into the interior.
flexible flat
cable
colored line
connector
2 chuck holder block
5 insulator
0 insulator
0 insulator
1 claw
1 claw
NG
Insert at a slant.
flexible flat
cable
colored line
connector
e i e
screw
5 insulator screw
7 connector
0 insulator
Wire e i
9 connector
1 claw
8 flexible flat cable (24P)
(FFC1)
1 claw
Note 2: Insert the connector straight into the interior.
There is a possibility that using this device without
the connector correctly installed will damage it.
OK
Insert straight into
the interior.
connector
connector
MHC-V6D
e e i
Terminal face is below side.
– ie –
B ie –
NG
Insert only part way. Insert at a slant.
connector
connector
connector connector
NG
33