Brother HL-5030 User Manual page 58

5
Pull out the MP tray support flap.
6
When putting transparencies in the MP tray, make sure they touch the back of the tray and remain
under the maximum paper height guides on both sides of the tray. Do not put more than 10
transparencies in the MP tray at any one time, or it may cause a jam.
Make sure that the transparencies are straight and in the proper position in the MP tray. If they are
not, the transparencies may not be fed properly, resulting in a skewed printout or a jam.
7
While pressing the paper-guide release lever, slide the paper guide to fit the transparency size.
Figure 1-52
Figure 1-53
Figure 1-54
ABOUT THIS PRINTER 1 - 41