Normal Sounds
Your new Beverage Center may make sounds that your old one
didn't make. Because the sounds are new to you, you might
be concerned about them. Most of the new sounds are normal.
Hard surfaces, such as the flooring and surrounding structures,
can make the sounds seem louder. The following describes the
kinds of sounds and what may be making them.
Your Beverage Center is designed to run more efficiently to
■
keep your food items at the desired temperatures and to
minimize energy usage. The high efficiency compressor and
fans may cause your Beverage Center to run longer than
your old one. You may also hear a pulsating or high-pitched
sound from the compressor or fans adjusting to optimize
performance.
Rattling noises may come from the flow of refrigerant or
■
items stored inside the Beverage Center.
As each cycle ends, you may hear a gurgling sound due to
■
the refrigerant flowing in your Beverage Center.
You may hear water running into the drain pan when the
■
Beverage Center is defrosting.
You may hear clicking sounds when the Beverage Center
■
starts or stops running.
Using the Control
The control panel is located on the middle separator (mullion)
of the Beverage Center. The control panel has no mechanical
parts or buttons.
Turning Control On/Off
The first time that the Beverage Center is plugged in, the
control will be in Off mode.
To turn ON the unit, press
To turn OFF the unit, press
Beverage Center Shelves
Your model may have glass or wire shelves. Store similar foods
together. This reduces the time the Beverage Center door is
open and saves energy.
To Remove and Replace Shelves:
1. Remove the shelf by lifting up the front and pulling it out of
the shelf slots.
2. Replace the shelf by inserting it into the shelf slots and
pushing it toward the back of the compartment.
Important information to know about glass shelves
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
Tempered glass is designed to shatter into many small,
pebble-size pieces. This is normal. Glass shelves and covers
are heavy. Use both hands when removing them to avoid
dropping.
BEVERAGE CENTER USE
button for 3 seconds.
button for 3 seconds.
BEVERAGE CENTER FEATURES
Viewing Celsius Temperatures
Press the
touch pad to toggle between displaying the
temperature in degrees Fahrenheit and degrees Celsius. The
corresponding indicator will illuminate.
Adjusting the Interior Light
Press
touch pad to toggle between ON and OFF.
Adjusting the Controls
There are three temperature control set points for this model:
For your convenience, your control is preset at the default
temperature.
To adjust set point temperatures, press "+" (plus) or "-"
■
(minus) until the desired temperature setting is reached.
NOTES:
The default recommended temperature for the Beverage
■
Center is 39°F (4°C) Upper Compartment and 55°F (13°C)
for Lower Compartment.
Wait at least 24 hours between adjustments so the Beverage
■
Center can acclimate.
Beverage Center
Upper
setting
Compartment
Cold
33°F (1°C)
Medium
39°F (4°C)
Cool
42°F (6°C)
Remove and Replace the Wine Racks
NOTE: When storing large bottles or magnums, remove the
rack directly above.
1. Pull the rack forward until it stops.
2. Lift up on the left-hand lever (A) while pressing down on the
right-hand lever to release the rack. Pull the rack forward
and lift it up and out of the rack supports.
A. Lever
3. Replace the rack by inserting the rack into the supports and
sliding it toward the rear of the Beverage Center.
Lower
Compartment
42°F (6°C)
50°F (10°C)
55°F (13°C)
7