90
Fastening the shrouds in frame size R8
Top entry busbar shroud
Place the top cover to
position (3) with the tabs
entering the slots of the
shroud.
Vertical busbar shroud
2
Remove the protective film from the
shroud surfaces.
1
Cut the corner piece
to make space for
the PE terminal of
the drive module.
Mechanical installation of non-pre-assembled units (ACS800-04M)
4
2
Remove the protective
film.
1
Step drill lead-throughs
for the busbars.
Used in the right-
hand-side assembly
Fasten the shroud plates to
3
each other and to the drive
module.
Fasten the
4
shroud to the
drive module.
Top entry busbar shroud fastened
Alternative
positions
Vertical busbar shroud fastened
Note: When connecting the power cables,
remove the front (and top and side) shroud by
undoing the fastening screws.
3