Sealey TP17 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to instruction Wear eye
manual
protection
1. SAFETY
WARNING! Ensure health & safety, local authority, and general workshop practice regulations are strictly adhered to when

using this equipment.
Familiarise yourself with product application and limitations, as well as the specific potential hazards peculiar to this product.

Maintain the pump in good condition (use an authorised service agent).

Replace or repair damaged parts. Use genuine parts only. Non authorised parts will invalidate the warranty.

Use only to pump oils up to SAE 80 viscosity.

Ensure safety eye protection and protective clothing are worn when using this product.

Keep the work area clean, uncluttered and ensure there is adequate lighting.

Maintain correct balance and footing. Ensure the floor is not slippery and wear non slip shoes.

Keep children and unauthorised persons away from the working area.

Dispose of waste liquids in accordance with local authority regulations.

DO NOT use to extract corrosive fluids.

DO NOT dismantle, tamper with or adapt the pump for any purpose other than for which it is designed.

DO NOT use the unit if it has been dropped or mishandled, check the unit to ensure there is no damage.

Keep the pump clean and store in a safe, dry, childproof location.

WARNING! DO NOT allow uncontrolled discharge of fluids thus polluting the environment.

2. INTRODUCTION
Steel construction self-priming lever pump. Features heavy-duty wheels and gripped handle for ease of manoeuvrability. Supplied with a 20ltr
reservoir, 1.9mtr delivery hose and flow control tap with angled spout. Spout holder within bucket cover for tidy storage when not in use. Suitable
for gear oil and fluids with similar viscosity.
fig.1
© Jack Sealey Limited
MOBILE GEAR OIL DISPENSING UNIT (20LTR)
TP17
MODEL No:
Wear protective
gloves
Original Language Version
fig.2
TP17 Issue:2 (HF SAE) - 08/10/18