Mitsubishi Electric MJ-E100AR-H Instruction Manual page 14

Dehumidifying (Cont.)
MILDEW GUARD
In this mode, the unit can dehumidify the bathroom to remove residual moisture and water drops, thus
suppressing the mildew growth as a means of mildew prevention.
To install the unit
Install the unit in the changing room
(entrance to the bathroom)
(Do not install inside the bathroom)
CAUTION
Do not use the unit in a bathroom or other
location where it is likely to come into
contact with water, or wash it with water.
Exposure to water may result in fire or electric shock
caused by an electric leak.
About MILDEW GUARD mode
The unit continues to operate for about another 4 hours after the humidity decreases to 50% and then stops
automatically.
The operation time varies depending on temperature and humidity and ranges from approximately 4 hours
(approximately 6 hours if the room temperature is below 20°C) to approximately 12 hours.
How is mildew growth suppressed?
Mildew is unable to produce new spores if it is dried as mycelia.
This principle is applied to the MILDEW GUARD function.
(However, the spores have high resistance to dryness.)
Operating each operation mode
Operation mode
EASY
AUTO
HIGH
LOW
MILDEW GUARD  (Operates for 4 to 12 hours)
14
Blowing air from
"downward air outlet"
Adjust the unit so that the
blowing air can be delivered
to every corner.
Close the bathroom window.
Cover the bathtub if there is
still some water inside.
Automatic stop Continuous operation
—
—
—
—
z For better results, do not turn on the room
ventilation fan or open the window or door when
the unit is operating.
z The results may vary depending on the size,floor
and wall materials of the bathroom.
z There may be some residual water drops in the
places that can collect water.
z Mildew growth may still occur due to the fungus
type and conditions of the room.
<e.g.> Under the containers of the bathroom,
deeper inside of closets and behind
furniture and places with bad air flow.
z Places such as inside of the bathtub, under
containers or where the blowing air cannot reach,
cannot be dried.
z This mode does not remove existing mildew,scales
and sticky liquids around the sinkhole.
z When it is used with the OFF TIMER mode,the unit
may stop operating before completing the drying
operation.
"Research of Black Mold"
Experimental data from General Incorporated
Association Mold Prediction Laboratory
Operation stops when the tank is full. To
restart operation, remove water from the
*
tank.
*

* Operates continuously according to the room

temperature and humidity. (Operates while
—
turning the blower and compressor ON and OFF)