Installing The Driver Software - Canon Powershot S10 Software Starter Manual

Installing the Driver Software

(Preinstalled Windows 98 Systems)
Note Regarding Installation
• The driver installation process will install two programs: USB Driver and
PowerShot USB TWAIN Driver.
• Do not cancel the installation partway through. Allow the procedure to finish completely
before exiting. The camera may not operate correctly if the installation is incomplete.
• The driver installation is only required the first time the camera is connected via the
USB interface. It is not required from the second time onward.
• Your computer may prompt you to insert the CD-ROM containing your Windows system
software during the installation. Have the Windows disk handy in case it is required.
1.
Attach the PowerShot S10/S20 to the computer's USB port and turn the
mode dial to the
The [Add New Hardware Wizard] will appear after a moment.
2.
Read the dialog and click the [Next] button.
The dialog will change to the search selection dialog.
What to Do if the Installation Does Not Proceed Properly
Read the Troubleshooting the Driver Software Installation section on page 30 if the
installation cancels itself during the procedure, if the installation does not proceed as
described in these procedures, or if you think that the drivers are not properly installed.
10
First USB Connection Only
position ( p. 8).