Table of Contents
Advertisement
D9133TTL-E | Installation Guide | 1.0
1.0 Introduction
Throughout the rest of this guide, the D9412GV2,
D7412GV2, D7212GV2, D9412G, D7412G,
D7212G, D9412, D9112, and D7212 will be
collectively referred to as "Bosch control panels."
The D9412G, D7412G, D7212G, D9412,
D7412, D7212, and D9112 must have
firmware version 6.30 or later.
These instructions are for installing and setting up the
D9133TTL-E Network Interface Module to work
with Bosch control panels as a SDI bus device.
The D9133TTL-E (Figure 1) is used for bi-directional
communications over Ethernet networks. Typical
uses include PC front-end software packages, local
RPS connection for programming, diagnostic
troubleshooting, Conettix D6600 Communications
Receiver/Gateway reporting and history retrieval.
Figure 1:
D9133TTL-E
These instructions contain procedures to
follow in order to avoid personal injury and
damage to equipment.
4
Introduction
2.0 Overview
2.1
2.1.1
Figure 2 shows a Conettix D6600 System using Bosch
Security Systems, Inc. Control Panels, D9133TTL-E
Network Interface, D6600, and D6680.
Figure 2:
1 - Bosch control panel
2 – Connection – control panel SDI bus to
3 - D9133TTL-E or DX4020
4 - Connection – D9133TTL-E/DX4020 Ethernet
5 - Host PC- 6200 Programming Administrative
6 - Connection – Ethernet hub to host PC Ethernet
7 - Ethernet hub
8 - Connection - Ethernet hub to D6680
9 - Conettix D6680 Network Ethernet adapter
10 - Connection - D6680 to D6600 COM1
11 - Conettix D6600 Central Station Receiver
12 - Connection - D6680 to D6600 COM4
13 - Connection - Ethernet hub to D6680
Bosch Security Systems, Inc. | 6/07 | 4998122717-01
System Interconnection
Conettix System
Conettix D6600 System Connection
Diagram using D9133TTL-E and
Bosch control panels
3
2
1
1 2 4 8
13
9
12
10
D9133TTL-E/DX4020 SDI bus
jack to Ethernet hub
Software
NIC
(optional)
4
5
6
7
8
9
11
Advertisement
Table of Contents
