Using The Breast Pump - Philips Avent SCF393 Manual

Step 3: Disinfecting
Supplies needed:
-
A household pot
-
Drinking-quality water
Caution: During disinfection with boiling water, prevent the bottle or other parts from touching the
side of the pot. This can cause irreversible product deformation or damage that Philips cannot be held
liable for.
5 min.
1. Fill a household pot with
enough water to cover all
parts and place all parts in
the pot. Let the water boil
for 5 minutes. Make sure the
parts do not touch the side
of the pot.

Using the breast pump

Cushion size
The Philips Avent single/double electric breast pump Plus has a soft, active cushion. There is only one cushion size.
It gently stimulates your nipple to trigger milk flow. The cushion is made of flexible silicone, fitting nipple sizes up to
30 mm/1.18 in.
Assembling the breast pump
Make sure you have cleaned and disinfected the parts of the breast pump that come into contact with milk.
Warning: Be careful, when you have disinfected the breast pump parts by boiling them, they can be
very hot. To prevent burns, only start assembling the breast pump when disinfected parts have cooled
down.
Warning: Wash your hands thoroughly with soap and water before you touch breast pump parts and
breasts to prevent contamination. Avoid touching the inside of containers or lids.
Check the breast pump kit parts for wear or damage before use and replace them if necessary.
Note: Correct placement of the cushion, silicone diaphragm and silicone tube is essential for the breast pump to form
a proper vacuum.
2. Allow the water to cool
down.
3. Gently remove the parts
from the water. Place the
parts on a clean surface/
tea towel or drying rack to
air-dry.
English
4. Store the dry items safely
in a clean, protected area
until needed. Ensure the
clean parts have air-dried
completely before storing
them to help prevent germs
and mold from growing.
11