Philips BT3206 Manual

1
2
3
4
English
Introduction
Congratulations on your purchase and welcome to
Philips! To fully benefit from the support that
Philips offers, register your product at
www.philips.com/welcome.
General description (fig. 1)
1 Trimming guard
2 Cutting unit
3 On/off button
4 Socket for small plug
5 Small plug
6 Battery charge indcator
7 Supply unit
not shown: cleaning brush
Important safety information
Read this important information carefully before
you use the appliance and its accessories and save
it for future reference. The accessories supplied
may vary for different products.
Danger
- Keep the supply unit dry (Fig. 2).
Warning
- To charge the battery, only use the detachable
supply unit (A00390) provided with the
appliance.
- The supply unit contains a transformer. Do not
cut off the supply unit to replace it with another
plug, as this causes a hazardous situation.
- This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved. Children
shall not play with the appliance. Cleaning and
user maintenance shall not be made by
children without supervision.
- Always check the appliance before you use it.
Do not use the appliance if it is damaged, as
this may cause injury. Always replace a
damaged part with one of the original type.
- Do not open the appliance to replace the
rechargeable battery.
Caution
- This appliance is not washable. Never immerse
the appliance in water and do not rinse it under
the tap (Fig. 2).
- Only use this appliance for its intended purpose
as shown in the user manual.
- For hygienic reasons, the appliance should only
be used by one person.
- Never use compressed air, scouring pads,
abrasive cleaning agents or aggressive liquids
such as petrol or acetone to clean the
appliance.
- Do not use the supply unit in or near wall
sockets that contain an electric air freshener to
prevent irreparable damage to the supply unit.
Electromagnetic fields (EMF)
This Philips appliance complies with all applicable
standards and regulations regarding exposure to
electromagnetic fields.
General
- The supply unit is suitable for mains voltages
ranging from 100 to 240 volts.
- The supply unit transforms 100-240 volts to a
safe low voltage of less than 24 volts.
Charging
Charge the appliance fully before you use it for the
first time and after a long period of disuse.
It takes approximately 10 hours to fully charge the
appliance. When it is fully charged, the appliance
has a cordless operating time of up to 45 minutes.
1 Make sure the appliance is switched off.
2 Insert the small plug into the appliance (Fig. 3).
3 Put the supply unit in the wall socket.
- The charging light on the supply unit lights up
green to indicate that the product is charging.
Note: The charging light on the supply unit does
not change color and does not go out when the
product is fully charged.
4 After charging, remove the supply unit from the
1
wall socket and pull the small plug out of the
appliance.
Optimizing the lifetime of the
rechargeable battery
When you have charged the appliance for the first
time, we advise you to use it until the battery is
completely empty. Continue to use the appliance
until the motor almost stops running during a
7
session. Then recharge the battery. Follow this
6
procedure at least twice a year.
5 - Slide the on/off button up to switch the
product on or off (Fig. 4).
Using the appliance
Note: Switch off and clean the appliance after each
use.
Always comb the beard and/or moustache with a
fine comb before you start trimming.
Be careful when you trim for the first time. Do
not move the trimmer too fast. Make smooth
and gentle movements.
Trimming with comb
Note: When you trim for the first time, start at the
highest length setting to familiarize yourself with
the appliance.
Use the trimming comb attached to the cutting
element to trim your beard and moustache in your
preferred style. Turn the zoom wheel to choose
from 11 length settings ranging from 0.5mm to
10mm (1/32in. to 13/32in.).
1 Slide the trimming comb straight into the
guiding groove of the appliance (Fig. 5).
2 Turn the zoom wheel to the desired setting (Fig.
6). The desired hair length setting is shown in
the center of the zoom wheel.
3 Switch the appliance on.
4 To trim most effectively, move the appliance
against the hair growth direction. Make sure
that the surface of the comb always stays in
contact with the skin.
Note: Since all hairs do not grow in the same
direction, you may want to try different
trimming positions (i.e., upwards, downwards, or
across). Practice is best for optimum results.
5 Regularly remove cut hair from the comb. If a lot
of hair has accumulated in the comb, remove it
from the appliance and blow and/or shake out
the hairs (Fig. 7).The selected hair length setting
does not change when the comb is removed.
6 Switch off and clean the product after each use
(see 'Cleaning').
Trimming for 'stubble look'
1 Be certain trimming comb is attached to the
appliance and use setting 0.5mm (1/32in.) to
create a 'stubble look' trim (Fig. 8).
Trimming without comb
Use the trimmer without the trimming comb to trim
the edges and single hairs.
Be careful when you trim without the comb as
the cutting unit will remove every hair it
touches.
1 Pull the trimming guard straight off the
appliance (Fig. 10).
2 Switch the appliance on.
3 Make well-controlled movements. Touch the
hair lightly with the trimmer (Fig. 9).
Cleaning
Never use scouring pads, abrasive cleaning agents
or aggressive liquids such as gasoline or acetone
to clean the product.
Never dry the trimmer teeth with a towel or tissue,
as this may damage the trimmer teeth.
Caution: Never use scouring pads, abrasive
cleaning agents or aggressive liquids such as
petrol or acetone to clean the appliance.
1 Switch off the appliance and disconnect it from
the power outlet.
2 Wipe the housing of the appliance with a dry
cloth.
Caution: Never immerse the appliance in water,
or rinse it under the tap. Only the cutting unit
can be rinsed under the tap.
3 Remove the comb (Fig. 10) and clean it with the
cleaning brush and/or rinse it under the tap.
4 Remove the cutting unit by pushing against the
teeth of the cutting unit (Fig. 11) and clean it with
the brush or rinse it under the tap.
5 Carefully shake off excess water and let air dry
completely.
6 Insert the lug of the cutting unit into the guiding
slot and push the cutting unit back onto the
appliance (Fig. 12).
Ordering accessories
To buy accessories or spare parts, visit
www.shop.philips.com/service or go to your
Philips dealer. You can also contact the Philips
Consumer Care Center in your country (see the
international warranty leaflet for contact details).
Recycling
- Do not throw away the product with the normal
household waste at the end of its life, but hand
it in at an official collection point for recycling.
By doing this, you help to preserve the
environment.
- This product contains a built-in rechargeable
battery which shall not be disposed of with
normal household waste. Please take your
product to an official collection point or a
Philips service center to have a professional
remove the rechargeable battery.
- Follow your country's rules for the separate
collection of electrical and electronic products
and rechargeable batteries. Correct disposal
helps prevent negative consequences for the
environment and human health.
BT3206
© 2018 Koninklijke Philips N.V.
All rights reserved
保留所有权利
4222.002.8958.2 (6/2/2018)
2
5
3 4 5 6
8
1 0.5
11
1
2
3 4
6 7
9 10
12