Sealey TP9424.V2 Instructions

thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to Wear eye
instructions protection
1. Safety
warning! Pump must be used in accordance with Health & safety, government, local authority, and water authority rules
‰
and regulations.
familiarise yourself with application and limitations, as well as the potential hazards peculiar to the pump.
9
warning! disconnect the pump from the battery before changing accessories, servicing or performing any maintenance.
‰
maintain the pump in good condition. Keep the pump clean.
9
replace or repair damaged parts (use an authorised service agent). use genuine parts only. non authorised parts may be
9
dangerous and will invalidate the warranty.
if the bottom of the liquid container is covered with sludge, sand, gravel or mud etc, suspend the pump or place it on a raised
9
base to operate above the solid matter. sand and such substances will reduce working life of pump, and invalidate your warranty.
in flood situations, user is responsible for ensuring that appropriate back up procedures, alarms etc are correctly installed in
9
case of pump failure.
in swimming pool, fish ponds, etc, ensure location is clear of people and animals (including removal of fish from pond).
9
note: this pump is not designed for continuous use in a fish pond or similar water feature or display.
Do not use with petrol or other volatile liquids within flashpoint range -20°c to +80°c.
8
Do not use to pump septic tanks or settling pits.
8
Do not operate the pump if any parts are damaged or missing as this may cause failure and/or personal injury.
8
Do not use the pump for any purpose other than for which it is designed.
8
Do not operate pump out of liquid. the pump pick up area must be completely submerged during operation.
8
Do not operate the pump during freezing temperatures. do not leave the pump in water that may freeze.
8
Do not carry the pump by its electrical cable, or outlet pipe.
8
When not in use remove battery clips from terminals. rinse pump, drain out any liquid and store in a frost free, safe location.
8
warning! Whilst the pump may be used in dirty water, it is not to be used for water containing large particles e.g. mud, weed
8
etc.
warning! Do not allow uncontrolled discharge of contaminated water/harmful chemicals thus polluting the environment.
8
warning! this pump must only be connected to a 24Vdc battery. do not attempt to connect to any other supply.
8
2. introDuction
robust and compact portable pump for use with diesel, non-aggressive chemicals and fresh or dirty water.
suitable for re-fuelling/fluid transfer of plant, agricultural and marine equipment on site. the pump is supplied with a 3mtr outlet hose and
stainless steel nozzle plus a 4mtr battery cable with clips. Will fit through a Ø54mm aperture to allow emptying of
containers. end cap can be unscrewed for periodic cleaning of the filter.
3. Specification
flow rate: ....................................................................15 ltr/min
Voltage: .......................................................................... 24Vdc
current: .........................................................................5∙3amp
duty cycle: ..................................................................15min/hr
4. contentS
unpack the product and check the contents. ensure that there is no
damage. if any problem is noted, contact your supplier immediately.
A ..... 3 metre outlet hose + stainless steel nozzle
B ..... motor
c ..... impeller guard
d ..... filter
e ..... end cap
f ..... Battery clips
G ..... 4 metre battery cable
H ..... seal cap
© Jack sealey limited
instructions for
low voltage SubmerSible tranSfer
pump 24v
model no:
Wear protective
gloves
Original Language Version
tp9424.v2
tP9424.V2 issue 2 (Hf) 15/12/17