Sealey TP94 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE
AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
WARNING! Pump must be used in accordance with Health & Safety, government, local authority, and water authority rules and regulations.
F
Familiarise yourself with application and limitations, as well as the potential hazards peculiar to the pump.
!
WARNING! Disconnect the pump from the battery before changing accessories, servicing or performing any maintenance.
F
Maintain the pump in good condition. Keep the pump clean.
!
Replace or repair damaged parts (use an authorised service agent). Use genuine parts only. Non authorised parts may be dangerous and will
!
invalidate the warranty.
If the bottom of the liquid container is covered with sludge, sand, gravel or mud etc, suspend the pump or place it on a raised base to
!
operate above the solid matter. Sand and such substances will reduce working life of pump, and invalidate your warranty.
In flood situations, user is responsible for ensuring that appropriate back up procedures, alarms etc are correctly installed in case of pump failure.
!
In swimming pool, fish ponds, etc, ensure location is clear of people and animals (including removal of fish from pond). Note: this pump is not
!
designed for continuous use in a fish pond or similar water feature or display.
DO NOT operate the pump if any parts are damaged or missing as this may cause failure and/or personal injury.
&
DO NOT use the pump for any purpose other than for which it is designed.
&
DO NOT use to pump septic tanks or settling pits.
&
DO NOT operate pump out of water. The pump pick up area must be completely submerged during operation.
&
DO NOT operate the pump during freezing temperatures. DO NOT leave the pump in water that may freeze.
&
DO NOT carry the pump by its electrical cable, or outlet pipe.
&
When not in use remove battery clips from terminals. Rinse pump, drain out any liquid and store in a frost free, safe location.
!
WARNING! Whilst the pump may be used in dirty water, it is not to be used for such water containing large particles e.g. mud, weed etc.
F
WARNING! DO NOT allow uncontrolled discharge of contaminated water/harmful chemicals thus polluting the environment.
F
2. INTRODUCTION & SPECIFICATIONS
Self priming portable pump for use with diesel, various chemicals, and fresh or dirty water. Suitable for re-fuelling/fluid transfer of plant, agricultural
and marine equipment on site. The pump is supplied with a 3mtr outlet hose and stainless steel nozzles, plus a 4mtr battery cable with clips.
Flow rate at hose end:
Voltage:
Current:
Pressure:
Diameter:
Length:
Weight:
Duty Cycle:
3. CONTENTS
Unpack the product and check the contents.
Ensure that there is no damage. If any problem is noted,
contact your supplier immediately.
A .......... 3 metre outlet hose + stainless steel nozzle
B .......... Motor
C .......... Impeller guard
D .......... Filter
E .......... End cap
F .......... Battery clips
G.......... 4 metre battery cable
H .......... Seal cap
16.5 ltr/m
12V
4.5amp / DC
15psi / 1bar
53.5mm
145mm
0.6kg
15mins
INSTRUCTIONS FOR:
SUBMERSIBLE TRANSFER PUMP
TP94
Model:
TP94 - 2 - 240703