Related Manuals for Hitachi CR12V
Summary of Contents for Hitachi CR12V
-
Page 2: Notes On Disassembly And Reassembly
MODELS CR 12V/CR 12 1. NOTES ON DISASSEMBLY AND REASSEMBLY: The circled numbers in the descriptions below correspond to the item numbers in the Parts Lists and ex- ploded assembly diagrams. 1-1. Diassembly: (1) Disassembly of the Upper Cover Ass’y After removing the Base and the Saw Blade , take off the Insulation Cover... - Page 3 1-2. Reassembly: Reassembly can be accomplished by following the disassembly procedures in reverse. However, special attention should be given to the following items. (1) Insert 30 g of grease (Molub-Alloy #1) into both the Gear Cover and Upper Cover. Also apply a liberal amount of grease to the following parts: The 6202VVCM Ball Bearing in the Gear Cover...
- Page 4 1-3. Wiring Diagram and Internal Wire Arrangements: (1) Model CR12V For European countries: Trigger Black Switch Control Circuit Armature Cord White or Blue Stator Ass’y Fig. 6 For N.Z.: Black White Trigger Black Switch Control Circuit Choke Armature Coil Cord...
- Page 5 For Australia: Trigger Black Switch Control Circuit Armature Cord Blue Stator Ass’y Fig. 8 For other countries: Trigger Black Switch Control Circuit Armature Cord White or Blue Stator Ass’y Fig. 9 − 4 −...
-
Page 6: For European Countries
For European countries: Trigger Switch Noise Suppressor Control Circuit Fig. 10 For N.Z.: Trigger Switch Noise Suppressor Choke Coil Control Circuit Fig. 11 − 5 −... - Page 7 (2) Model CR12 For European contries: Trigger Switch Armature Cord Stator Ass’y Fig 12 For N.Z.: Black White Trigger Switch Choke Armature Coil Cord Stator Ass’y White Black Fig 13 For Australia: Trigger Switch Armature Cord Stator Fig 14 Ass’y −...
- Page 8 For other countries Trigger Switch Armature Cord Stator Ass’y Fig. 15 For European countries: Trigger Switch Noise Suppressor Fig. 16 − 7 −...
- Page 9 For N.Z.: Trigger Switch Noise Suppressor Choke Coil Fig. 17 1-4. Remaingin Reassembly: Remaining reassembly can be accomplished by following the disassembly procedures in reverse. 1-5. Insulation Tests: On completion of disassembly and repair, carefully measure the insulation resistance and conduct dielectric strength test.