Mitsubishi Electric AG-150A Installation Manual page 10

2. To route the cable from the bottom
(1) Remove the cover of Mounting attachment A type.
(Refer to section 1.(1).)
(2) Cut out the knockout hole on the Mounting attachment A type (PAC-YG85KTB) at the bottom with a nipper for the cable.
NOTE
Install the Mounting attachment A type (PAC-YG85KTB) so that
the arrow ( UP) on the back of it points up.
(3) Sand the cut surface of the knockout hole smooth.
CAUTION
Any rough edges that are left may damage the cable and cause electric shock or fire.
(4) Install the Mounting attachment A type (PAC-YG85KTB) with
the six mounting screws (field-supplied).
Use screws that are suitable for the wall type.
Install it on the surface strong enough to support its weight.
(Refer to section 1.(4).)
(5) Push the cable through the knockout hole.
Wall
M-NET transmission cable
- 10 -
Knockout hole
NOTE
Install the Mounting attachment A type (PAC-YG85KTB)
so that the arrow ( UP) on the back of it points up.
Protective earth (ground) cable
AC power cable