Height Adjustment; Operation; Fan Speed; Oscillation - Silvercrest SV 60 A2 Assembly, Operating And Safety Instructions

Fig. Step
Place the rear grille 2 on the main unit 16 .
Make sure to align the rear grille's 2 round
C
holes over the 3 mounting lugs on the main
unit 16 . Secure the grille with the grille lock
nut 3 . Rotation direction:
Install the blade 4 onto the shaft of motor
16a until it fits securely with the retaining pin of
D
the motor shaft . Secure it with the blade lock
nut 5 . Rotation direction:
NOTE: Make sure the 10 positions of the
grille collar 7 properly click into place at
the edge of the front grille 6 .
Use a screwdriver (not included) to unscrew
E
the locking screw from the hinged clip 8 .
Place the front grille 6 on the rear grille 2 .
The hook of the grille collar 7 needs to be
hooked into the rear grille 2 .
Secure both grilles 2 / 6 by closing
the hinged clip 8 . Use a screwdriver (not
F
included) to secure the locking screw onto the
hinged clip 8 .
˜ Height adjustment
Loosen up the adjustment knob 13 in anti-
clockwise direction (see Fig . F) .
Adjust the length of the upper pole 14 .
When the height is set, secure the position by
tightening the adjustment knob 13 in clockwise
direction (see Fig . F) .
˜ Operation
.
˜ Fan speed
.
˜ Oscillation
Place the product on a flat, stable ground .
Connect the power plug to a suitable power
socket .
Turning the product on/off: Press
Press 21 repeatedly to toggle between the
6 fan speeds:
Display Function
1
Lowest speed
6
Highest speed
When the product is on, press
between different oscillation modes:
Press
Indicator Function
1x 17 Horizontal oscillation
2x 18 Vertical oscillation
3x 19 Vertical / horizontal

oscillation

4x Oscillation stops
NOTES:
You can also adjust the angle of the product
manually by pulling it lightly up / down
(see Fig . G) .
Do not adjust the angle when the product is in

operation .

23 .
20 to toggle
GB 13