Sealey SA91.V3 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. SAFETY
Follow all Health & Safety and general workshop rules, regulations and conditions when using the wrench.
9
WARNING! Disconnect from air supply before changing accessories or servicing.
‰
Maintain the wrench in good condition and replace any damaged or worn parts. Use genuine parts only. Unauthorised parts may be
9
dangerous and will invalidate the warranty.
WARNING! Check correct air pressure is maintained and not exceeded. We recommend 90psi.
‰
Keep air hose away from heat, oil and sharp edges. Check air hose for wear before each use and ensure that all connections are secure.
9
Only use impact sockets which are specifically designed for use with an impact wrench.
9
Wear approved safety eye/face shield, ear defenders and hand protection.
9
WARNING! Due to the possible presence of asbestos dust from brake linings, when working around vehicle brake systems we
‰
recommend you wear suitable respiratory protection.
Maintain correct balance and footing. Ensure that the floor is not slippery and wear non-slip shoes.
9
Keep children and non-essential persons away from the work area.
9
DO NOT use the wrench for a task that it is not designed to perform.
8
WARNING! DO NOT use the wrench if it is damaged or thought to be faulty.
‰
DO NOT use wrench unless you have been instructed in its use by a qualified person.
8
DO NOT carry the wrench by the air hose, or yank the hose from the air supply.
8
DO NOT operate the wrench if you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
To avoid unintentional starting DO NOT carry the wrench with your finger on the trigger.
9
DO NOT direct air from the air hose at yourself or others.
8
When not in use, disconnect from the air supply and store in a safe, dry, childproof location.
9
2. INTRODUCTION
Fingertip forward/reverse throttle control. Fitted with rocking-dog clutch, nine-position air/torque control and Z-swivel air inlet. One-handed
operation and compact size make this tool especially suitable for engine bay work.
3. SPECIFICATION
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . .SA91.V3
Drive: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3/8"sq
Breakaway Torque:. . . . . . . . . . . . . . . . 130lb.ft (177Nm)
Maximum Torque: . . . . . . . . . . . . . . . . . 120lb.ft (162Nm)
Free Speed: . . . . . . . . . . . . . . . . . . . . . . . . . 10,000rpm
Air Consumption: . . . . . . . . . . . . . . . . . . . . . . . . . . 3cfm
Operating Pressure: . . . . . . . . . . . . . . . . . . . . . . . .90psi
Air Inlet: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1/4"BSP
Vibration: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5.17m/s²
Uncertainty: . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.5m/s²
Noise Power: . . . . . . . . . . . . . . . . . . . . . . . . . 102dB(A)
Noise Pressure: . . . . . . . . . . . . . . . . . . . . . . . . 91dB(A)
Nett Weight: . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.83kg
© Jack Sealey Limited
AIR IMPACT WRENCH 3/8"SQ DRIVE
MODEL NO:
Wear protective Wear ear
gloves protection
Original Language Version
SA91.V3
Wear a mask
SA91.V3 | Issue 1 09/11/18