AEG DVD-R 4518 Operation Manual page 72

Changing the default settings Themen
System Setup -
Record
72
05-DVD-R 4518 AEG - GB 72
Analog audio output
Here the settings for the analogue audio output are defi ned.
2 CH: An analogue stereo signal is produced. Use this setting if
you are using a two-channel stereo amplifi er.
5.1 CH: An analogue surround sound signal is produced. Use this
setting if you have a 5.1 amplifi er.
NOTE:
If there is no Audio output, even though you connected the DVD
recorder to an amplifi er, you will most likely have chosen an incorrect
setting for the Audio output.
Auto chapter marker
With this function your recordings are divided up into equal chapter
lengths. You can switch the function „on" or „off".
Default source
Here you can set the preferred input for the recording signal. The
following options are available.
CVBS
CVBS rear
S-Video rear
DV
SCART
Tuner
Default quality
Here you can set the preferred recording quality. The following options
are available.
HQ (high quality)
SP (normal recording quality)
EP (prolonged recording with reduced quality)
SLP (long recording with low quality)
05.07.2006, 10:31:30 Uhr