Powerbrush Maintenance - Electrolux BEAM Alliance Solaire Manual

3. Do not immerse in water or allow water to enter the Powerbrush.
For top cleaning performance, it is recommended that the brush roller and the brush roller
compartment be cleaned on an occasional basis.
WARNING: Always switch off the Powerhead and disconnect plug from wall outlet and
disconnect hose before servicing the Powerbrush.
1. Turn the Powerbrush upside down.
2. Press the 3 snap release clips (as shown in Figure 5)
and remove brush cover.
3. The brush roller is now exposed for removal of fi bers,
hair, etc. from the bristles and around the brush roller.
4. To remove fi bers or hair entangled around the brush
roller, cut parallel to brush roller.
5. You may further clean the brush compartment with your
central vacuum system.
6. Replace the brush cover by inserting the tabs on
the front of the cover into the appropriate slots in the
Powerbrush base (as shown in Figure 6) and press
down on the three clips until they snap-lock into place.
How to Change Cogged Belt.
WARNING: Always switch off the Powerbrush and disconnect plug from wall electrical outlet
and disconnect the hose before servicing the Powerbrush.
1. Remove the brush cover as described in "Brush Roller Cleaning" steps 1 and 2.
2. Insert a string around the brush roller close to the
cogged belt. Pull both ends of the string upwards so
that the brush roller disengages from the base (as
shown in Figure 7. Similarly, disengage the other end.
3. Remove and clean the bearing shaft from the
brush roller ends. Notice the bearing shafts are not
symmetrical. The slanted one belongs to the Brush gear
(cogged belt side, as shown in Figure 8).
6
BRUSH ROLLER CLEANING

POWERBRUSH MAINTENANCE

Figure 5.
Figure 6
Figure 7.