Chapter 24
Configuring BXM Virtual Circuits
You can configure the range of VPIs and VCIs reserved for PVC traffic and SVC traffic
Note
by using the cnfport command. While adding connections, the system checks the entered
VPI/VPC against the range reserved for SVC traffic. If there is a conflict, the addcon
command fails with the message "VPI/VCI on selected port is reserved at local/remote
end".
BXM Commands
This section provides a preliminary summary of configuration, provisioning, and monitoring
commands associated with the BXM cards. These commands apply to initial card configuration, line
and trunk configuration and provisioning, and connection configuration and provisioning.
Connection Provisioning
•
•
•
Diagnostics
•
•
•
Test
•
•
Statistics
•
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
addcon
Add connection
cnfcon
Configure connection
dspcon
Display connection
addlnloclp
Add local loopback to line
addlnlocrmtlp
Add local remote loopback to line
dellnlp
Delete local or remote loopback
tstconseg
Test connection externally with OAM segment loopback cells
tstdelay
Test connection round trip delay
Line and Trunk statistics
cnflnstats
–
Configure line statistics collection
–
dsplnstatcnf
Display statistics enabled for a line
–
dsplnstathist
Display statistics data for a line
–
cnftrkstats
Configure trunk statistics collection
–
dsptrkstatcnf
Display statistics enabled for a trunk
Cisco BPX 8600 Series Installation and Configuration
BXM Commands
24-3