About This Guide; Optional Accessories; Hardware Overview; System Requirements - D-Link DWL-6610AP Quick Installation Manual

About This Guide

This installation guide provides basic
instructions for installing the DWL-6610AP Unified
AC Concurrent Dual-band PoE Access Point on
your network. For additional information about
how to use the Access Point, please see the User
Manual, which is available on the CD included in
this package or from the D-Link support website.

System Requirements

- CD-ROM Drive
- Windows , Macintosh
®
operating system
- Ethernet port or installed Ethernet adapter
- Internet Explorer 7.0, Safari 5.0, Firefox 4.0,
or higher

Unpacking the Product

Open the shipping carton and carefully unpack its
contents. Please consult the packing list located
in following information to make sure all items are
present and undamaged. If any item is missing
or damaged, please contact your local D-Link
reseller for replacement.
- DWL-6610AP Unified AC Concurrent Dual-band
PoE Access Point
- Mounting Ring
- Console Cable
- CD-ROM
- Ceiling Bracket (3 sets, sizes are 9/16", 14/16",
and 1 1/2")
2  D-Link DWL-6610AP Quick Install Guide
, or Linux-based
®

Optional Accessories

- PoE Base Unit (Model: DPE-101GI)
Note: These accessories are not included in
the package. If any of these items are required,
please contact your reseller to order it.

Hardware Overview

LEDs
Figure 1. DWL-6610AP LEDs
POWER – When the LED is lit up, the
access point is powered and
ready for use.
LAN – When this LED is lit up, the
device's Ethernet port is
connected to an active router or
switch. The light will blink when
there is traffic going through the
port.
2.4GHz/5GHz – When the LED is lit up, the
access point's radio is enabled.
It will blink when there is wireless
traffic.
Interfaces
Power Receptor
LAN Port (PoE)
Figure 2. DWL-6610AP Rear Panel
Console Port