Sealey MK62 Instructions

thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instructions
1. safety
familiarise yourself with the application, limitations and hazards of the panel stand.
9
maintain the panel stand in good condition (use authorised replacement parts).
9
Keep the panel stand clean for best and safest performance.
9
locate the panel stand in a suitable work area.
9
WaRning! use the panel stand on level and solid ground, preferably concrete.
‰
do not overload the panel stand.
8
do not climb on the panel stand.
8
do not use the panel stand for any purpose other than for which it is designed.
8
do not use the panel stand if any parts are damaged or missing as this may cause failure and/or personal injury.
8
Keep the work area clean, uncluttered and ensure that there is adequate lighting.
9
Keep children and unauthorised persons away from the work area.
9
WaRning! the warnings, cautions and instructions discussed in this manual cannot cover all possible conditions and situations that
‰
may occur. it must be understood that common sense and caution are factors which cannot be built into this product, but must be
applied by the operator.
2. intRoduction
suitable for supporting multiple panels and trims including wings, bumpers and spoilers. eight adjustable bars and 360° rotation make this
stand suitable for almost any panel types. Portable for easy manoeuvring of application from preparation to spray booth. Built-in storage tray
for easy and convenient selection
3. specification
model no .......................................................................mK62
overall length ......................................................... 1600mm
short Adjustable Bar (x4) ........................................... 450mm
long Adjustable Bar (x4) ............................................ 750mm
Height (without Bars) ................................................ 1070mm
maximum capacity .........................................................90Kg
4. asseMbly
4.1. Attach fixed pole (10) and tray (16) to the front brace (9), and rear
brace (11) using bolts (9A), washers (9c) and nuts (9B).
4.2. Attach the two wheel poles (12) to the rear brace (11) using bolts
(11A), washers (9c) and nuts (9B).
4.3. check that the frame is square and fully tighten all fixings.
4.4. Attach wheels (13) to the wheel poles and secure with large
washer (15) and cotter pin (14).
4.5. lay the frame carefully on its side and slide the front bar (9G)
through the lower bracket on the front brace (9), position the
spring (9H) above the bracket and slide the front bar through the
spring and through the top bracket.
4.6. Attach the foot pedal to the front brace and to the base of the front
bar using bolts (9d) and nuts (9e).
4.7. upright the frame, the spring will rest on the lower bracket, lift the
pedal up until the bolt hole in the front bar is clear of the spring
and insert the spring retaining bolt (9J) and secure with nut (9K).
Press the pedal down and lock the bar down with safety pin (9i).
4.8. slide the buckles onto pole (6) alternate each one as shown in the assembly drawing (fig.1). insert extension pole (7) through the rear
brace and into pole (6), secure using bolt (7A), insert the
© Jack sealey limited
instructions for
Rotating univeRsal panel stand
MK62
model no:
Original Language Version mK62 | issue 1 10/08/16