Creating Dynamic Ipv6 Or Static Ipv6 Wan Connection - D-Link AC1200 User Manual

DIR-842V2 AC1200 Wi-Fi Gigabit Router
User Manual

Creating Dynamic IPv6 or Static IPv6 WAN Connection

On the connection creation page, in the General Settings section, select the relevant value from
the Connection type drop-down list and specify the needed values.
Figure 67. The page for creating a new Static IPv6 connection. The General Settings section.
Parameter
Interface
Connection name
Enable connection
NATv6
Ping
General Settings
A physical or virtual WAN interface to which the new connection
will be assigned.
A name for the connection for easier identification.
Move the switch to the right to enable the connection.
Move the switch to the left to disable the connection.
If the switch is moved to the right, the network address translation
function for IPv6 is enabled. Do not disable the function unless your
ISP requires this.
If the switch is moved to the right, the router responds to ping
requests from the external network through this connection. For
security reasons, it is recommended to disable this function.
Page 72
Configuring via Web-based Interface
Description