Fujitsu UTY-CDPXZC Design & Technical Manual page 30

 Set temp. range (Initial)
The set temperature range of the wired remote controller can be restricted from the begin-
ning.
Set the set temperature range of each operation mode.
NOTES:
• In the case of dual remote control operation, make the primary unit and the secondary
unit setting same. Even if only the primary unit is set, it will not be reflected at secondary
unit.
• After setting, always perform operation. Since the indoor unit memorizes the last opera-
tion, overwriting the memory operation mode is unnecessary.
 Room temp. correction
The value sensed by the temperature sensor listed in the wired remote controller can be cor-
rected.
Set the correction value.
- 26 -