Table of Contents
Advertisement
Troubleshooting
Problem
Burner(s) will not light
using ignitor.
Burner(s) will not
match light.
Sudden drop in gas
flow or low flame.
Flames blow out.
Flare-up.
Persistent grease fire
(can damage the
appearance of
aluminum castings
on the grill).
Flashback...
(fire in burner tube(s).
Unable to fill LP tank.
26 • 463845504
Possible Cause
• Wire and/or electrode covered with
cooking residue.
•
Electrode and burner are wet.
•
Electrode cracked or broken "sparks at
crack"
•
Wire is loose or disconnected.
•
Wire is shorting (sparking) between
ignitor and electrode.
•
Bad ignitor.
•
No gas flow.
•
Coupling nut and regulator not fully
connected.
•
Obstruction of gas flow.
•
Disengagement of burner to valve.
•
Is grill assembled correctly?
•
Out of gas.
•
Excess flow valve tripped.
•
High or gusting winds.
•
Low on LP gas.
•
Excess flow valve tripped.
•
Grease buildup.
•
Excessive fat in meat.
•
Excessive cooking temperature.
•
Grease trapped by food buildup around
burner system.
•
Burner and/or burner tubes are blocked.
•
Some dealers have older fill nozzles
with worn threads.
Prevention/Solution
•
Clean wire and/or electrode with rubbing alcohol and clean swab.
• Wipe dry with cloth.
•
Replace electrode.
• Reconnect wires or replace electrode/wire assembly.
• Replace ignitor wire/electrode assembly.
• Replace ignitor.
• Check to see if LP tank is empty. If LP tank is not empty, refer to
"Sudden drop in gas flow"
below.
• Turn the coupling nut about one-half to three quarters additional
turn until solid stop. Tighten by hand only; do not use tools.
•
Clear burner tube(s).
• Reengage burner and valve. Reattach spring clips.
• Check steps in assembly instructions.
• Check for gas in LP tank.
• Turn off knobs, wait 30 seconds and light grill. If flames are still low,
turn off knobs and LP tank valve. Disconnect regulator. Reconnect
regulator and leak test. Turn on LP tank valve, wait 30 seconds and
then light grill.
• Turn front of grill to face wind or increase flame height.
• Refill LP tank.
• Refer to
"Sudden drop in gas flow"
• Clean grill.
• Trim fat from meat before grilling.
• Adjust (lower) temperature accordingly.
• Turn knobs to OFF. Turn gas off at LP tank. Leave lid in position and
let fire burn out.
After grill cools, remove, clean all parts and replace
grease can.
• Turn knobs to OFF. Clean burner and/or burner tubes.
• The worn nozzles don't have enough "bite" to engage the valve. Try
a second LP dealer.
above.
Advertisement
Table of Contents
