Troubleshooting; Indicator Display Troubleshooting - Panasonic BL-C20 Troubleshooting Manual

Troubleshooting

The Panasonic Network Camera support website "http://panasonic.co.jp/pcc/
products/en/netwkcam/" includes various technical information in addition to the
contents in this troubleshooting section. Access the website if this troubleshooting
does not solve your problem.

Indicator Display Troubleshooting

Problem
The indicator
lights or blinks
orange.
The indicator
continues
blinking orange.
The indicator
continues
blinking orange
(2-second
interval).
• The Ethernet cable is not connected properly.
Connect the Ethernet cable properly.
• The PC, the Ethernet hub or router is not working.
Confirm that PC, Ethernet hub and router are working.
• The switch on the side of the camera is set to WIRELESS when
trying to connect in wired mode, or to WIRED when trying to
connect in wireless mode.
Set the switch to the corresponding mode.
• The wireless settings do not match those of the router.
Set the same SSID, Communication mode and WEP as
those of the router.
• The camera is turned off when updating firmware.
If you access the camera using a web browser, the Update
Firmware page will be displayed. Update the firmware
following the procedure (see page 114 of the Operating
Instructions on the CD-ROM). If you fail to update the
firmware, see page 17.
• The router on your network is turned off.
Turn the router on, and wait until the ADSL line is connected.
Then turn the camera off and on again.
• An error has occurred in UPnP
Turn the camera off and on again. If the error still occurs, set
up the camera again in [Automatic Setup] using the Setup
Program following the instructions in Getting Started.
Cause and Remedy
port forwarding.
TM
Troubleshooting
3