Table of Contents
Advertisement
TG8011E(e).book Page 38 Tuesday, June 23, 2009 8:50 AM
Useful Information
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
Display message
Cause/solution
L The supplied telephone line cord has not been
Check Tel Line
L Phonebook copy failed (page 22). Confirm the other
Failed
L The receiver's phonebook memory is full. Erase the
Incomplete
L The phonebook memory is full. Erase unnecessary
Memory Full
L The maximum number of base units (4) is already
L The handset has lost communication with the base
No link to base.
Reconnect AC
adaptor.
L Unplug the base unit's AC adaptor to reset the unit.
L The handset's registration may have been cancelled.
L A wrong type of batteries such as Alkaline or
Use rechargeable
battery.
L You must subscribe to a Caller ID service. Once you
You must first
subscribe to
Caller ID.
38
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
connected yet or not connected properly. Check the
connections (page 12).
handset (the receiver) is in standby mode and try
again.
unnecessary phonebook entries from the other
handset (the receiver) and try again.
entries (page 21).
registered to the handset. Cancel unused base unit
registrations from the handset (page 29).
unit. Move closer to the base unit and try again.
Reconnect the adaptor and try again.
Re-register the handset (page 28).
Manganese was inserted. Use only the rechargeable
Ni-MH batteries noted on page 4, 13.
receive caller information after subscribing to a Caller
ID service, this message will not be displayed.
Advertisement
Table of Contents
