JVC KD-S821R Service Manual page 6

KD-S821R
Removing the main board
Prior to performing the following procedure, remove
the front panel assembly, the front chassis assembly,
the heat sink and the bottom cover.
1. Remove the screw B, the two screws C and the
three screws D attaching the rear bracket on the
back of the body. Remove the rear panel.
2. Remove the two screws E attaching the main board
on the bottom of the body. Disconnect connector
CN501 on the main board in the direction of the
arrow.
Removing the CD mechanism section
Prior to performing the following procedure, remove
the front panel assembly, the front chassis assembly,
the heat sink, the bottom cover and the main board.
1. Remove the three screws F
mechanism section on the back of the top chassis.
1-6
(See Fig.7 and 8)
D
(See Fig.9)
attaching the CD
Rear panel
D
Fig.7
E
CN501
Fig.8
CD mechanism section
F
F
Fig.9
B C
C
D
Main board
E
F
Top chassis